Soldering Station Variable Temperature (302ºF to 896ºF) with built-in stand, TMC

Temperature Controlled Solder Station by TMC ELECTRONICS SPECIFICATIONS:ON/OFF Switch with « Power ON » indicator lightVariable 302ºF to 896ºF heat setting to match specific soldering needsBuilt-in Dual Spring Stand for maximum heat dissipationCushioned rubber grip for extended comfortable useHeating Element: 50WExtra Long Life Tip includedAvailable replacement Tips: 608-TIP, 608-TIP/A, 608-TIP/F and 608-TIP/G (Sold separately)Available replacement Nut: 608-NUT (Sold separately)Available replacement Heating Element: 608-50HEAT (Sold separately)Available replacement Sponge: 608-SPONGE (Sold separately)Tip Replacement and Dressing:Tip replacement or cleaning should be done only when the iron is at room temperature. The tip can be changed or replaced simply by unscrewing the knurled nut from the barrel assembly. The station must be switched off and allowed to cool before and during this operation, as damage may result if the system is left on without the tip installed. After removing the tip, blow out any oxide dust that may have formed in the tip retaining area of the barrel. Be careful to avoid getting debris in your eyes. Replace the tip and screw the retaining knurled nut onto the barrel assembly; tighten only finger-tight. To avoid burning your fingers, pliers should only be used to tighten the nut if it becomes loose when the iron is hot. Care should be taken not to over-tighten, as this can damage the element.