Cleanable Filter for Milwaukee M12 Right Angle Die Grinder 2485 2485-20 2485-22
For sale is a removable, cleanable, and reusable motor intake filter for the Milwaukee M12 Right Angle Die Grinder. The built-in filter for the die grinder can never be removed and is difficult to clean, leading to restricted airflow, overheating, and reduced tool life. It also has a very coarse mesh, allowing smaller particles into the motor. This aftermarket filter simply slips over the existing air intake and is held securely in place with tabs and a rubber band. It is easy to remove and clean out. It also has a much larger surface area but a finer mesh, preventing more debris from getting into the tool while providing the same airflow. The filter housing is made of nylon and the filter element is made of extra-fine, long-lasting stainless steel mesh and can simply be washed out with water or blown out with air. Protect your investment in one easy step! Buy with confidence, 100% feedback! Made in the USA!
Wrench Holder for Milwaukee M12 Fuel 3″ Compact Cut Off Tool 2522-20 2522-21
For sale is a wrench holder attachment for the Milwaukee M12 Fuel 3″ Compact Cut Off Tool. Designed to securely and conveniently hold the hex wrench used to change out cut-off disks. Save time and aggravation by having the wrench always attached to the tool itself! This wrench holder screws onto the front of the tool using an existing fastener. Made of strong, flexible nylon. Buy with confidence, 100% feedback! Made in the USA!
Sanding Pad Adapter for Milwaukee M12 Detail Sander 2531-20
For sale is a sanding pad adapter for your Milwaukee Detail Sander that allows you to swap out the default detail sanding pad for other sizes and shapes of sanding pads.It has pre-made holes for common round sanding pad sizes. You can also screw this into a piece of wood or plastic, add some stick-on velcro, and use it as your own custom sanding pad shape. Made of strong but lightweight nylon, which is an expensive material to use but ensures long-term durability and keeps the adapter light enough to not stress the tool and maintain battery life. Note that you may need to do some small modifications to the sanding pad you intend to use – for example, drill a hole through the center to allow you to screw the mounting bolt in. Screw hole dimensions, from hole center to hole center: Triangle Pattern: 1-7/16 inch (~36.5mm)Small Square Pattern: 1-1/8 inch (~28.5mm) from hole to nearest hole, 1-5/8 inch (~41mm) from hole to opposite corner holeLarge Square Pattern: 1-3/8 inch (~35mm) from hole to nearest hole, 2 inch (~51mm) from hole to opposite corner hole