ShopSmith *Rebuilt* Drive Sleeve Assembly – Nylon Drive, Steel See Pics (#7)
That way I know it has arrived safely. Used working condition: Item(s) may show normal wear & tear. View Photos of actual item.
Shopsmith Mark V Molder Head 505553
Used item. Good working condition.
SHOP FIND-SHOPSMITH MARK V -TUBE END AND BASE
FRESH INDIANA SHOP FIND= SHOP SMITH.
shopsmith mark v complete
This is a Mark 4 with an 11 inch bandsaw with more accessories
Shopsmith 10ER Quill.
used in good condition, see pics.
Shopsmith Parts
Shows signs of age and long-term storage. Condition Unknown. Dirty. Rusty. Not Flawless. Correct Fitment Unknown. Verify Fitment before purchasing. Sold as a lot
Shopsmith Motor 3/4
Rebuilt a few years ago and never installed. This is an older 3/4 hp General Electric motor.
Vintage Shopsmith/Craftsman
Vintage Shopsmith/Craftsman miter gauge with pistol grip hold-down. The clamping bar is adjustable. The handle has a « trigger » which when squeezed shut, clamps down on the wood. The angle adjustment has a spring loaded pin for some standard angle settings. The bar is 12 3/4 inches long from the face–it is 3/4 inches wide and 3/8 inches thick. It is not marked, but all bar measurements indicate it would be compatible for use on most Craftsman 10″ table saws Please email me if you have any questions or if you would like to see any additional photos of particular area. I welcome all questions and would much prefer to address any issues before you bid. NOTE: I ESTIMATE ALL SHIPPING COST BASED ON EAST COAST TO WEST COAST RATES AS I HAVE NO WAY OF KNOWING WHERE IT WILL EVENTUALLY GO–SHOULD THE ACTUAL SHIPPING COST BE LESS, I PROVIDE A REFUND