Table Saw Adjuster for 1/2″ Arbor wFlat & New Big Spinner
This listing is for ONE replacement adjuster wheel for a Table Saw with 1/2″ – .500″ adjuster shafts and New Bigger Spinner Handles. BEFORE YOU BUY: Measure the adjuster shafts on your saw, if they are not 1/2″, .500″ in diameter, they will not fit. DO NOT PURCHASE! Measure the widest width of the shaft…not from the flat to the edge. This adjuster also comes with a tool to install the nut on the bolt in the spinner recess. These have been fit tested on a Craftsman and other brand Table Saws. These handle wheels are 4.75″ in diameter and will fit adjusters having a 1/2″ .500″ diameter shaft with a flat. The handle wheel has been beefed up more than the original plastic wheel handle that came on the saw. These are made on a 3D printer and I have a set on my table saw. The shaft diameter again is 1/2″ .500″ with a flat. The spinner for the adjuster mounts on a 1/4 x 1-1/2″ bolt and a NyLock nut which is included. We include a tool for this too. You will have to use the screw that came with your saw to hold the adjuster wheel on your saw. Most saws use 8-32 x 3/4″ or 10-32 x 3/4″ machine screw and washer to hold the handle wheel on the shaft. These handle wheels are a less expensive way to put the vise grips back in the tool box and make saw adjustments like you used too. Thanks for your purchase from Ben’s Creations.
ONE Handle Wheel for Table Saws with 3/8″ Adjustment Arbor Shafts
BEFORE YOU BUY: Measure the adjuster shafts on your saw, if they are not 3/8″, .375″ in diameter, they will not fit. DO NOT PURCHASE! Measure the widest diameter of the shaft, not from flat to edge. This listing is for ONE replacement handle wheel for Table Saws with 3/8″ .375″ adjuster shafts. These handle wheels will fit various brand table saws that have 3/8″ .375″ diameter arbor shafts with a flat. The handle wheel has been beefed up more than the original plastic wheel handle that came on the saw. My wheel handle adjusters broke before it was a month old. I had been using vise grips to turn the adjuster for the last twenty years. I made these on a 3D printer and have a set on my table saw. The handle wheels are 3.50″ in diameter with adjuster shafts 3/8″ .375″ with a flat. You will need to use the center screw that came with the saw to hold the handle wheel on the shaft. Most saws use 8-32 x 3/4″ or 10-32 x 3/4″ machine screws with a washer to hold the handles on. The finger spool for the wheel is a 1/4 x 2″ Tap bolt and a Nyloc nut which is included. These handle wheels are a less expensive way to put the vise grips back in the tool box and make saw adjustments like you used too. Thanks for your purchase from Ben’s Creations.