Table Saw Adjuster for 1/2″ Arbor wFlat & New Big Spinner

This listing is for ONE replacement adjuster wheel for a Table Saw with 1/2″ – .500″ adjuster shafts and New Bigger Spinner Handles. BEFORE YOU BUY: Measure the adjuster shafts on your saw, if they are not 1/2″, .500″ in diameter, they will not fit. DO NOT PURCHASE! Measure the widest width of the shaft…not from the flat to the edge. This adjuster also comes with a tool to install the nut on the bolt in the spinner recess. These have been fit tested on a Craftsman and other brand Table Saws. These handle wheels are 4.75″ in diameter and will fit adjusters having a 1/2″ .500″ diameter shaft with a flat. The handle wheel has been beefed up more than the original plastic wheel handle that came on the saw. These are made on a 3D printer and I have a set on my table saw. The shaft diameter again is 1/2″ .500″ with a flat. The spinner for the adjuster mounts on a 1/4 x 1-1/2″ bolt and a NyLock nut which is included. We include a tool for this too. You will have to use the screw that came with your saw to hold the adjuster wheel on your saw. Most saws use 8-32 x 3/4″ or 10-32 x 3/4″ machine screw and washer to hold the handle wheel on the shaft. These handle wheels are a less expensive way to put the vise grips back in the tool box and make saw adjustments like you used too. Thanks for your purchase from Ben’s Creations.