Sherline 1015 – 5/32 Inch Drill Chuck with #0 Morse Arbor
Specifications
| All Returns Accepted | ReturnsNotAccepted |
| Brand | Sherline Tools |
| Chuck Size | 5/32 inch |
| Model | 1015 |
| MPN | sher-1015 |
| Country/Region Of Manufacture | United States |
| Suitable For | Home Improvement |
Sherline 1015 - 5/32 Inch Drill Chuck with #0 Morse Arbor Sherline 1015 5/32 Inch Drill Chuck with #0 Morse Arbor ***The P/N 1015 Chuck is identical in capacity to the 1010 chuck shown except that a #0 Morse arbor has been pressed into the Jacobs taper in the back of the chuck. It is used in the tailstock and does not require a drawbolt*** We supply a #0 Morse arbor for use in the tailstock for center drilling. The chucks are also available with a #1 Morse arbor and drawbolt for use in the headstock for drilling on the lathe or mill. They are available in 5/32, 1/4 and 3/8 sizes. Runout is .003 or less. If runout of less than this amount is required, collets should be used to hole the drill rather than a chuck.The P/N 1015 Chuck is identical in capacity to the 1010 chuck. It is used in the tailstock and does not require a drawbolt. NOTE: Because the arbor is pressed into the chuck, it is not interchangeable from chuck to chuck. A separate chuck must be purchased for #0 and #1 Morse use Shipping Delivery time: To keep shipping costs as low as possible we ship USPS Ground (7-10 day) Payment We accept the following payment methods: Paypal Service International Shipments: We cannot guarantee any specific delivery times.